This complete 5.7L INBOARD MPI engine package is designed to replace most INBOARD 5.0L (305ci) and 5.7L (350ci) marine engine  INBOARD applications. It is available in standard rotation AND reverse rotation. This engine package and 100% of the components are brand new and includes a 2 year factory warranty. If you have an existing Crusader, PCM, Indmar, Mercruiser, or any other inboard or V-drive setup with a  5.0L or 5.7L inboard engine, then this 5.7L MPI engine will work in your existing boat. Use your existing Borg Warner, ZF Hurth, Velvet Drive, etc transmission or we can supply you with a new transmission. This 5.7L MPI engine includes a 4th generation ECM (MEFI 4 controller) that prevents the engine from overheating, provides 15%-30% better gas mileage, built-in engine rev limiter, and added horsespower/torque over the 5.7L carbureted version. This 5.7L MPI engine is rated at 325hp and is set up for an inboard application (top mount starter, inboard bell housing, inboard fly wheel, dampner plate, dual remote oil filter). Also includes returnless single fuel line hookup for easy installation. This complete 5.7L engine is ran, properly timed and tested BEFORE it is shipped to you. This engine package includes:

• 5.7L Vortec base marine engine (standard rotation)
• Multi-port fuel injection intake manifold
• MEFI IV computer / controller
• Stainless-steel flexible fuel lines (U.S.C.G. approved)
• Hi and low pressure fuel pumps (U.S.C.G. approved)
• Oil pressure switch, oil sending unit, knock sensor, misc sensors
• Electronic ignition (Electronic distributor w/ coil, spark plug wires, spark plugs, etc)
• 14" INBOARD flywheel, bell housing & dampner plate
• Center-rise exhaust manifolds with 4" risers
• Throttle bracket, throttle clip and quick connect ball joint
• 70 amp alternator, bracket, and tensioner (U.S.C.G. approved)
• High torque top or bottom mount starter (U.S.C.G. approved)
• MPI Engine wire harness with universal ten pin plug
• Water/fuel separator
• Crank driven seawater pump
• Dual remote oil filter setup
• Thermostat housing w/ thermostat
• Adjustable engine motor mounts
• Flame arrester and weather cover
• Dip stick tube, dip stick and EZ oil drain hose
• Corrosion resistant black urethane paint
• ALL pulleys, hoses, belts installed
• MPI diagnostic tool 
• Two year limited warranty

Available Options:

Closed cooling kit Rear Mount:	($899.00)
Closed cooling kit Front Mount:	($899.00)
Cast aluminum oil pan:	($299.00)
Reverse rotation:	($849.00)

$8,349.00 $7,699.00 plus shipping!

Item number: MPS5.7L-MPI